Round-the-Clock Soot Removal in Lemhi County County, ID

24/7 Emergency Response, Board-Up and Roof Tarping

The first visit is about stopping things from getting worse. To fight a fire, crews often break windows and cut roof vents, and that leaves the property open to weather, animals and trespassers. An emergency crew boards openings with plywood or OSB, tarps roof penetrations, and can set temporary fencing where the property is exposed.

• Board-up of broken windows and doors
• Roof tarping over ventilation cuts and burn-through
• Water extraction from firefighting runoff
• Initial photo documentation for your insurer

Residential Fire Damage Removal

House fires almost never stay in one room. Heat cracks drywall, smoke travels through return ducts into bedrooms, and soot lands on everything from hanging clothes to the top of the fridge. Residential crews map damage room by room, decide what can be cleaned versus replaced, and tear out charred material until they reach sound framing.

Charred studs and joists are typically cleaned back by wire brushing, sanding or soda blasting and then sealed with a shellac-based primer that locks in odor. If the char runs deep enough to weaken a board, the contractor marks it for sistering or replacement before new drywall goes on. Skipping this step is how a smoke smell resurfaces a couple of humid summers later.

Commercial Fire Damage Removal

When a business closes, the losses start before the cleanup does. Commercial fire restoration is about phasing: getting a section back open while crews keep working behind containment. Contractors set up for commercial work can run night shifts, coordinate with property managers and adjusters, and document everything for business interruption coverage.

• Restaurants and commercial kitchens with grease and protein residue
• Retail, office and warehouse spaces
• Multi-unit residential and rental properties
• Sprinkler discharge cleanup alongside smoke damage

Smoke and Soot Removal

Soot comes in several types, and the wrong cleaning method can ruin a wall that was salvageable. Dry soot from hot, fast-burning wood and paper fires lifts off with HEPA vacuums and dry sponges. Wet soot from slow, smoldering plastics is greasy and smears. Protein residue from burned food barely shows at all. Puff-back soot from an oil furnace is thick, black and oily.

A good crew tests a small area first, identifies the residue, and picks the cleaning chemistry to match. That could be dry chemical sponges on flat paint, alkaline degreasers on cabinet faces, or dry ice blasting across exposed attic framing. Surfaces that cannot be cleaned are sealed or replaced.

Smoke Odor Removal and Indoor Air Cleanup

Of everything a fire leaves behind, the smell is what homeowners underestimate most. The particles are tiny and they work into insulation, carpet pad, upholstery and the inside of ductwork. Real odor removal is a sequence: remove the source, clean what stays, then treat the air and remaining materials.

• HEPA air scrubbers to capture airborne soot during work
• Thermal fogging that mimics how smoke penetrated
• Hydroxyl generators, which can run in occupied spaces
• Ozone treatment in unoccupied rooms when appropriate
• HVAC and duct cleaning so the system stops recirculating odor

Ozone is effective, but it is not safe for people, pets or plants, and it can degrade rubber and some fabrics. Ask the contractor which method they plan to use and why. If they give you a clear answer, that is a good sign.