Fire Damage Removal in Travis County County, TX

Emergency Fire Damage Response and Board-Up

The first visit has one goal: stop the damage from spreading. To fight a fire, crews often break windows and cut roof vents, and that leaves the property open to weather, animals and trespassers. An emergency crew boards openings with plywood or OSB, tarps roof penetrations, and can set temporary fencing where the property is exposed.

• Board-up of broken windows and doors
• Roof tarping over ventilation cuts and burn-through
• Water extraction from firefighting runoff
• Initial photo documentation for your insurer

Home Fire Damage Cleanup and Removal

House fires almost never stay in one room. Heat breaks open the drywall paper, smoke rides the return air into bedrooms, and soot settles on everything from closet clothing to the top of the refrigerator. A residential crew maps the damage room by room, separates what can be cleaned from what has to go, and removes charred materials down to sound framing.

Char on studs and joists is usually removed by wire brushing, sanding or soda blasting, then sealed with a shellac-based primer to lock in residual odor. If the char runs deep enough to weaken a board, the contractor marks it for sistering or replacement before new drywall goes on. Skipping this step is how a smoke smell resurfaces a couple of humid summers later.

Commercial Fire Damage Removal

When a business closes, the losses start before the cleanup does. Commercial restoration is mostly about phasing the work so part of the space reopens while crews keep going behind plastic containment. Contractors who handle commercial losses can work after hours, coordinate with your property manager and insurer, and keep the paperwork clean enough for a business interruption claim.

• Restaurants and commercial kitchens with grease and protein residue
• Retail, office and warehouse spaces
• Multi-unit residential and rental properties
• Sprinkler discharge cleanup alongside smoke damage

Smoke and Soot Removal

Not all soot is the same, and using the wrong method can make a cleanable wall unrecoverable. Dry soot from hot, fast-burning wood and paper fires lifts off with HEPA vacuums and dry sponges. Wet soot from smoldering plastics is sticky and smears. Protein residue from burned food barely shows at all. Fuel oil soot from a furnace puff-back is heavy and black.

A good crew tests a small area first, identifies the residue, and picks the cleaning chemistry to match. That could be dry chemical sponges on flat paint, alkaline degreasers on cabinet faces, or dry ice blasting across exposed attic framing. Surfaces that cannot be cleaned are sealed or replaced.

Smoke Odor Removal and Indoor Air Cleanup

Of everything a fire leaves behind, the smell is what homeowners underestimate most. The particles are tiny and they work into insulation, carpet pad, upholstery and the inside of ductwork. Real odor removal is a sequence: remove the source, clean what stays, then treat the air and remaining materials.

• HEPA air scrubbers to capture airborne soot during work
• Thermal fogging that mimics how smoke penetrated
• Hydroxyl generators, which can run in occupied spaces
• Ozone treatment in unoccupied rooms when appropriate
• HVAC and duct cleaning so the system stops recirculating odor

Ozone works, but it is unsafe for people, pets and plants and can break down rubber and certain fabrics. Ask the contractor which method they plan to use and why. A straight answer is a good sign.