After the Fire Trucks Leave: Fire Damage Removal in Strafford County County, NH

Emergency Fire Damage Response and Board-Up

The first visit has one goal: stop the damage from spreading. To fight a fire, crews often break windows and cut roof vents, and that leaves the property open to weather, animals and trespassers. An emergency crew boards openings with plywood or OSB, tarps roof penetrations, and can set temporary fencing where the property is exposed.

• Board-up of broken windows and doors
• Roof tarping over ventilation cuts and burn-through
• Water extraction from firefighting runoff
• Initial photo documentation for your insurer

Residential Fire Damage Removal

In a house, fire damage is rarely confined to one room. Heat breaks open the drywall paper, smoke rides the return air into bedrooms, and soot settles on everything from closet clothing to the top of the refrigerator. Residential crews map damage room by room, decide what can be cleaned versus replaced, and tear out charred material until they reach sound framing.

Charred studs and joists are typically cleaned back by wire brushing, sanding or soda blasting and then sealed with a shellac-based primer that locks in odor. If the char runs deep enough to weaken a board, the contractor marks it for sistering or replacement before new drywall goes on. This is the step that keeps a smoke smell from returning two summers later.

Commercial Fire Damage Removal

When a business closes, the losses start before the cleanup does. Commercial fire restoration is about phasing: getting a section back open while crews keep working behind containment. Contractors set up for commercial work can run night shifts, coordinate with property managers and adjusters, and document everything for business interruption coverage.

• Restaurants and commercial kitchens with grease and protein residue
• Retail, office and warehouse spaces
• Multi-unit residential and rental properties
• Sprinkler discharge cleanup alongside smoke damage

Soot Cleaning and Smoke Residue Removal

Not all soot is the same, and using the wrong method can make a cleanable wall unrecoverable. Dry soot from fast, hot fires of wood and paper vacuums and sponges off reasonably well. Wet soot from slow, smoldering plastics is greasy and smears. Protein residue from burned food is nearly invisible. Fuel oil soot from a furnace puff-back is heavy and black.

A good crew tests a small area first, identifies the residue, and picks the cleaning chemistry to match. That could be dry chemical sponges on flat paint, alkaline degreasers on cabinet faces, or dry ice blasting across exposed attic framing. Anything that will not come clean gets sealed or replaced.

Smoke Odor Removal and Indoor Air Cleanup

Smoke odor is the part of fire damage that people underestimate most. Smoke particles are small enough to work into insulation, carpet pad, upholstery and duct interiors. Real odor removal is a sequence: remove the source, clean what stays, then treat the air and remaining materials.

• HEPA air scrubbers to capture airborne soot during work
• Thermal fogging that mimics how smoke penetrated
• Hydroxyl generators, which can run in occupied spaces
• Ozone treatment in unoccupied rooms when appropriate
• HVAC and duct cleaning so the system stops recirculating odor

Ozone works, but it is unsafe for people, pets and plants and can break down rubber and certain fabrics. It is fair to ask the contractor which method they plan to use and why. If they give you a clear answer, that is a good sign.