Commercial Fire Damage Restoration in Newport County County, RI

Emergency Fire Damage Response and Board-Up

The first visit is about stopping things from getting worse. Firefighters break windows and cut ventilation holes in roofs to get a fire out, which leaves the structure open to rain, animals and anyone walking by. Emergency crews cover openings with plywood or OSB, tarp the roof, and put up temporary fencing if the site is exposed.

• Board-up of broken windows and doors
• Roof tarping over ventilation cuts and burn-through
• Water extraction from firefighting runoff
• Initial photo documentation for your insurer

Residential Fire Damage Removal

In a house, fire damage is rarely confined to one room. Heat cracks drywall, smoke travels through return ducts into bedrooms, and soot lands on everything from hanging clothes to the top of the fridge. Residential crews map damage room by room, decide what can be cleaned versus replaced, and tear out charred material until they reach sound framing.

Charred studs and joists are typically cleaned back by wire brushing, sanding or soda blasting and then sealed with a shellac-based primer that locks in odor. If the char runs deep enough to weaken a board, the contractor marks it for sistering or replacement before new drywall goes on. Skipping this step is how a smoke smell resurfaces a couple of humid summers later.

Fire Damage Removal for Businesses and Rental Properties

When a business closes, the losses start before the cleanup does. Commercial fire restoration is about phasing: getting a section back open while crews keep working behind containment. Contractors set up for commercial work can run night shifts, coordinate with property managers and adjusters, and document everything for business interruption coverage.

• Restaurants and commercial kitchens with grease and protein residue
• Retail, office and warehouse spaces
• Multi-unit residential and rental properties
• Sprinkler discharge cleanup alongside smoke damage

Soot Cleaning and Smoke Residue Removal

Not all soot is the same, and using the wrong method can make a cleanable wall unrecoverable. Dry soot from hot, fast-burning wood and paper fires lifts off with HEPA vacuums and dry sponges. Wet soot from slow, smoldering plastics is greasy and smears. Protein residue from burned food barely shows at all. Puff-back soot from an oil furnace is thick, black and oily.

A good crew tests a small area first, identifies the residue, and picks the cleaning chemistry to match. That might mean dry chemical sponges on flat paint, alkaline degreasers on kitchen cabinets, or dry ice blasting on exposed framing in an attic. Surfaces that cannot be cleaned are sealed or replaced.

Smoke Odor Elimination and Air Quality Restoration

Smoke odor is the part of fire damage that people underestimate most. The particles are tiny and they work into insulation, carpet pad, upholstery and the inside of ductwork. Real deodorization happens in order: remove the source, clean what remains, then treat the air and structure.

• HEPA air scrubbers to capture airborne soot during work
• Thermal fogging that mimics how smoke penetrated
• Hydroxyl generators, which can run in occupied spaces
• Ozone treatment in unoccupied rooms when appropriate
• HVAC and duct cleaning so the system stops recirculating odor

Ozone works, but it is unsafe for people, pets and plants and can break down rubber and certain fabrics. Ask the contractor which method they plan to use and why. If they give you a clear answer, that is a good sign.